Paul, I am also seeing a strange problem. I did a calibration update to my ECM. The truck will no longer remote start. V2 shows no DTC either direct or through the scan tool. My stand alone code reader will not connect?
Rock
Paul, I am also seeing a strange problem. I did a calibration update to my ECM. The truck will no longer remote start. V2 shows no DTC either direct or through the scan tool. My stand alone code reader will not connect?
Rock
I no longer monitor the forum, please either post your question or create a support ticket.
If this is just a firmware issue, it wouldn't affect me if I haven't updated any firmware correct? I have only extracted the files and run the scanner/tuner, and uploaded calibrations to the car(unless it does an automatic firmware upgrade). I have noticed on 2 occasions in the past few days where I uploaded a cal to my car and after the guages did not reset and would not reset with key on/off until I reuploaded the file.
01 C5 'vert A4
EFILive, PLX, & TNT are all we got at the moment.
Before asking for help, please read this.
what was the solution to joshh mystery codes? I had the same thing happen to me yesterday. Got done with a pull and lost power and set a CEL. checked with scan tool and flashscan and no codes. Didn't read this post til now so didn't generate a bug report or save anything on flashscan. I just pressed clear codes on flashscan and light went away.
kev
The LBZ/LMM controllers are bosch controllers and they reply to the FlashScan scan tool a little differently than the Delphi controllers.
It ended up being a timing issue. FlashScan was just not waiting long enough for the Bosch controller to send the codes.
A new version that fixes the problem is available here:
http://forum.efilive.com/showthread.php?t=8384
Just posted an hour ago.
Regards
Paul
Before asking for help, please read this.
I used auto update on 8.1.1 and it worked but on 7.5.4 it said there were no updates. My scan tool and tune tool still say build 62??? Do I need to install off web site and if so, do I need to make "old" folders as to not overwrite files?
Kevin
Yes, you need to install V7.5.4 from here:
http://forum.efilive.com/showthread.php?t=8384
V7.5.3 has not been released as an auto update install yet.
Yes, the V7.5.4 (build 63) install is the last version where you will need to do that. Once this version (build 63) is installed, all future installs will not overwrite your config files.
Installing build 63 will also reset the registry entries for both the Scan and Tune tool. That will cause window sizes and placements and property settings to get reset to install defaults. You will need to go into the properties window in both scan and tune and re-apply any settings that you require.
Regards
Paul
Before asking for help, please read this.