BBL installer update: June 22, 2008

[Aint Skeered]

When you see the 08 error for sensor timing, it means the sensor heater is dying....(as per innovate tech line)

Ouch...they cost.
Chuck CoW

IT lasted almost a year and worked great untill I checked the air fuel on a freinds car with a 408 and he was running wal mart gas with the 10 % ethelyne mix. he was at 12/1 and man that sensor was clean when we took it out. Looked very lean.

I guess from now on any one who wants to use the lm1 has to buy there own sensor.

[joecar]

I think they're about US$50 from autopart.com

Part number: 021-906-262-B or 021906262B

Check the 2nd and 4th items (SG897) in this list: http://www.autopart.com/O2Sensor/O22...AGENBEETLE.htm

I believe this is the right part... someone might want to cross-check it;

otherwise they are about $75-$100 elsewhere.

[Chuck CoW]

I think they're about US$50 from autopart.com

Part number: 021-906-262-B or 021906262B

Check the 2nd and 4th items (SG897) in this list: http://www.autopart.com/O2Sensor/O22...AGENBEETLE.htm

I believe this is the right part... someone might want to cross-check it;

otherwise they are about $75-$100 elsewhere.

Is this the one used for the LM1??

Chuck CoW

[vxleather]

Ok did some more testing this morning, Made a new option file last night as per photo below... when i loaded the bbl in to Scan tool, the afr worked well, averything was there bar KR !!!! it is in the option file, can anyone see anything wrong with the file???

The pid is blanked out so i can not pick it once I open the BBL log file in scan... any suggestons..

[Ninety8C5]

You need a comma after the KR, because you put the alarm information after the PID. Look at the ECT and RPM PIDS under PSL_LS2.

[Blacky]

You need a comma after the KR, because you put the alarm information after the PID. Look at the ECT and RPM PIDS under PSL_LS2.

Well spotted.

Regards
Paul

[Ninety8C5]

Well spotted.

Regards
Paul

Thanks,

Easy to spot when you've done the exact same thing.

[vxleather]

Thanks guys....

Will know for next time know....

[Chuck CoW]

Ok, so I'm Fed up with LM1....Damn power socket keeps breaking off the circuit board and hate the power switch that always turns itself on....and everything else.....

I've been seeing the LM2 everywhere but nobody has it on the shelf...Anyone have or use it yet????

ANYWAY, the reason to bring this up.... Can we expect that the serial protocol will be the same as LM1 meaning that we can just plug it into Flashscan and it will read serial WB....

Or, do we have to get it added into the Firmware to recognize it??

Chuck CoW

[Blacky]

ANYWAY, the reason to bring this up.... Can we expect that the serial protocol will be the same as LM1 meaning that we can just plug it into Flashscan and it will read serial WB....

Or, do we have to get it added into the Firmware to recognize it??

Chuck CoW

As far as I am aware it should just plug in and work with the existing FlashScan firmware. If it doesn't I guess I'll be lining up to get an LM2 to make it work.

Regards
Paul