Flashscan data logging..

[joecar]

Do you see the Options.ini file under either of these places:
C:\Program Files\EFILive\V8.1\Programs
C:\Program Files\EFILive\V8.1\Config

Drag the Options.ini from the upper pane (one of those 2 folders) to to lower pane (Config Files tab).

Once you have done that you are ready to log (disconnect laptop, restart V2, on V2 select the PCM that is for your WS6 (LS1B_A for A4, LS1B_M for M6).

PM your phone #.

[waterbug1999]

I believe its all read done.. i just dont understand how to get it to the V2.

[waterbug1999]

Here ya go..

[waterbug1999]

here ya go..

[joecar]

Jody,

Save the contents of the .zip and drag it to the Config Files tab under EE.

This Options.ini has 5 example pid lists for LS1B_A (LS1B = 1999+ LS1, A = A4).

When you goto "Select PIDs" on the V2 menu, you will see those 5 pid lists.

[waterbug1999]

You are the man!!! Thanks a bunch!

[joecar]

To do serial AFR logging from the LC-1, see this pic:



You need to join those 2 cables using the null-modem adapter shown, or you can buy an LC-1 serial cable from TAQuickness;

The stereo jack plugs into the LC-1's SERIAL OUT cable.

This will allow you to display the wideband AFR as a pid on your V2 LCD.

[waterbug1999]

I have a wideband in the car so I can see the AF... But, I think you said it will just show Volts correct? But, once uploaded, it will turn into AF on the efilive "tune"?

[joecar]

If your wideband is connected to V2 via analog (LC-1 brown signal wire, white/green ground wire), then you will only see the voltage on the V2 LCD (you will see the AFR when you view using the ScanTool).

[joecar]

Hmmm.... maybe I can edit this into the Options.ini file...

Do you use the pid CALC.AFR_LC11...?