Flashscan data logging..

[waterbug1999]

If your wideband is connected to V2 via analog (LC-1 brown signal wire, white/green ground wire), then you will only see the voltage on the V2 LCD (you will see the AFR when you view using the ScanTool).

They way it is now, is just brown for + and a ground I zipped into the floorboard (took the paint off of coarse) and called it -.

[waterbug1999]

Hmmm.... maybe I can edit this into the Options.ini file...

Do you use the pid CALC.AFR_LC11...?

Oh no, I dont know what that means?

[joecar]

Oh no, I dont know what that means?

Post one of your log files (use the Manage Attachments button)...

If your LC-1 is set to default, then in the EFILive software scantool you would be using the pid CALC.AFR_LC11.

[joecar]

Jody, and others using the LC-1,

Try this Options.ini for displaying LC-1 standard default analog AFR...

First open the .zip file and save the .ini to your hard disk (overwrite your old Options.ini);
then using EE drag the new Options.ini to the Config Files tab, overwriting the old file.

On the V2, go into Edit Settings... and set A/D Pids to Yes.

Then during logging (pids are shown updating on the V2 LCD), scroll down to the bottom, you will see AD1 and AD2...
press the Enter key and AD1 and AD2 will change to AFR_WB1 and AFR_WB2...

-->> I haven't tried it yet, so let me know if it works or not.

Cheers
Joe

[waterbug1999]

the V2 and everything else is in the car and ready for a trial run tomorrow.. The lap top will join that stuff pretty soon as well.

Joecar, thanks a lot oh wise one! ill post up tomorrow and let ya know if I ran into any problems.

[waterbug1999]

Ended up getting a personal best at 10.71 @ 126 and a 10.77 @ 126. Here are a couple of vids.. I logged, or think I did log 2 N20 runs. How do I retrieve them again?

http://www.youtube.com/watch?v=qmNpy2rHi3s

http://www.youtube.com/watch?v=HJ2jtECCb6w

[waterbug1999]

Isnt that the log?? I forgot what you told me on Friday..

[joecar]

Good ET...

Goto the Scan Files tab, the log should be there (filename looks like BBLxxxx.efi)...
drag the .efi file(s) up to the top pane (first select the folder in the top pane).

[waterbug1999]

I dont see anything...

[waterbug1999]

ok.. i got it. it wasnt recognizing the SD card was present. I had to pop it out, then put it back in then a refresh. And it reads it now.