How do I do that? The new version is completely different.
How do I do that? The new version is completely different.
Start Scan&Tune, then click on BBL...
a gui opens up...
in upper left, on a controller/pidlist name do rightclick->Properties and select you controller...
then drag pids from right pane to lower left pane...
the red/green indicator bars at the bottom tell you if there are too many pids (all red)...
then save and program to V2.
Start from post #207: showthread.php?p=94917#post94917
My PID menu doesn't have all of those PIDs available and they all have "(sample)" next to each menu item in the upper left corner.
I got it figured out. I like the new EFI Explorer better. It's easier to use now that I know how to use it. However, I can't select the PIDS to display in Imperial by hitting Enter on the BB. I also tried to change it under Settings but that didn't work either.
In the BBL pids gui, in the lower left pane (the pids that will be BBL'd), do this:
on a pid (say VSS) do rightclick->Properties and fill in the Custom Properties (set it to mph)...
don't forget to save/program.