You should take some logs to see how your tune is performing:
VSS
RPM
DYNCLYAIR
DYNAIR
MAF
MAP
LONGFT1
LONGFT2
SPARKADV
KR
IAT
ECT
TFT
GEAR
TCCMODE
TFMPRS
LASTSHIFT
On the PIDs tab keep the channel count 24 or less.
You should take some logs to see how your tune is performing:
VSS
RPM
DYNCLYAIR
DYNAIR
MAF
MAP
LONGFT1
LONGFT2
SPARKADV
KR
IAT
ECT
TFT
GEAR
TCCMODE
TFMPRS
LASTSHIFT
On the PIDs tab keep the channel count 24 or less.
thanx joecar i will try and do that as soon as get a bit of time
04 gmc cc 4x4 6ltr tuned by w4me
operator error
efi-live v2 sitting on shelf
i am to dumb to operate
Oh, my bad, it is called SHIFTLAST.
To set that pid list in your V2 you have to run V8.1 Scan&Tune...
You set the name/controller in the blue section (rightclick->Properties, select controller, change name)...
then drag pids from the yellow section to the green section, arrange the order of the pids in the yellow section,
watch the green/blue box bargraph at the bottom of the yellow section, when it turns red you have too many pids/channels.
then save and program to V2.
thanx joecar i named it after ya
04 gmc cc 4x4 6ltr tuned by w4me
operator error
efi-live v2 sitting on shelf
i am to dumb to operate