Results 1 to 4 of 4

Thread: AEM X-Series WB took out my Cluster/Aux BCM???

  1. #1
    Senior Member
    Join Date
    May 2014
    Posts
    125

    Default AEM X-Series WB took out my Cluster/Aux BCM???

    Not sure where to post this.
    2012 Vagon.
    Bought and installed the AEM X-series WB with the Canbus OBD port option and as soon as it was plugged in, it took out the cluster. Tech2 shows no comm on cluster and other devices

    Something AEM tech mentioned was that some of these cars have a known issue of active weird when OBD devices are connected and that there
    Last edited by Mean Green Z28; October 24th, 2022 at 01:19 AM.

  2. #2
    New Member
    Join Date
    Oct 2022
    Posts
    1

    Default

    I have the same problem too

  3. #3
    Senior Member
    Join Date
    May 2014
    Posts
    125

    Default

    Quote Originally Posted by ViktorY View Post
    I have the same problem too
    Same as in cluster went out or other modules start acting up but reset once the gauge is disconnected?


    Sent from my iPhone using Tapatalk

  4. #4
    Senior Member
    Join Date
    May 2014
    Posts
    125

    Default

    So far I got advice to remove fuses 52/60/64 under the hood and also remove battery (not concurrently) and connect terminals together for a LONG time to discharge any capacitors in the system that may hold any charge to do a full reset. Let

Similar Threads

  1. The AEM 30-0334 OBDII X-Series Wideband for FlashScan V2 is finally available,
    By dr.mike in forum General (Petrol, Gas, Ethanol)
    Replies: 103
    Last Post: September 21st, 2021, 08:09 AM
  2. Aem x series calc pids
    By ksmrz in forum E37, E38 & E67 PFI ECM's
    Replies: 6
    Last Post: August 28th, 2019, 06:07 AM
  3. AEM X-Series OBDII Wideband UEGO AFR Sensor Controller Gauge
    By Gelf VXR in forum General (Petrol, Gas, Ethanol)
    Replies: 206
    Last Post: July 24th, 2017, 07:58 AM
  4. AEM X-Series Wideband - Serial
    By Gregs in forum General (Petrol, Gas, Ethanol)
    Replies: 43
    Last Post: April 13th, 2017, 07:20 AM
  5. Replies: 4
    Last Post: July 6th, 2008, 03:34 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •