Time for some 2014 corvette support on built cars?

[Highlander]

No need to run SD for the surge.

[RandyWS6]

No need to run SD for the surge.

Im new with the LT1 E92 ecm. I had a A&A super charger installed with Kook Long Tubes & X pipe installed and the tuner told me that the mass air is not located in the right place , witch is causing a surge at cruse or on a hill under load , WOT is fine. The blow off valve is open or the engine is not under boost. But the tuner told me if I run it in SD the surge was gone and the engine run perfect. They use HPT to dyno tune the car. I have the HPT SD tune but cant convert it to EFI Live . I have duel PLX WB ready to install so I can try to get the surge out of it.

[cindy@efilive]

E92 calibration files are updated in our December 28 release, which is currently being tested.

This development includes a range of new calibrations along with new operating system support and ECM locking to prevent tune copying.

Cheers
Cindy

[RandyWS6]

So when are we looking to go public on the update ?

[GMPX]

Unfortunately with the Christmas rush there was some files omitted from the intended release build, early next year at this stage for the release as staff are on holidays now.

[TDH]

Unfortunately with the Christmas rush there was some files omitted from the intended release build, early next year at this stage for the release as staff are on holidays now.

Any idea when we will see this release update? I recently acquired EFI Live Flashscan V2 with the gm licenses and did not adequately research that many of the features weren't available yet. Any info you can give me is appreciated.

Thank you.

[cindy@efilive]

A week to 2 weeks at most.

Cheers
Cindy

[TDH]

Thank you. I am looking forward to it.

[RandyWS6]

A week to 2 weeks at most.

Cheers
Cindy

Are we getting close for the LT1 update ??

[TDH]

Are we getting close for the LT1 update ??

...