Update: Feb 14, 2015

[2013_Cummins]

It is a bug in the V7 PID configuration for CMD/CME controllers. I'll post an updated cummins_enahnced.prn file. Look in the "known issues" thread for the update in a few minutes.

Regards
Paul

I still recieve the following error if I select the CME2350B controller and then close and try to re-open v7.5 Scan Tool


Error report generated by EFILive at 20:36:27 on Feb 15, 2015

Error code: ERR_CONFIG/92
C:\Program Files (x86)\EFILive\V7.5\Configuration\cummins_enhanced. prn(968): Units may not be specified for slot: SED-08-5010. .

EFILive Version: 7.5.7 (Build 278)

[Blacky]

I still recieve the following error if I select the CME2350B controller and then close and try to re-open v7.5 Scan Tool


Error report generated by EFILive at 20:36:27 on Feb 15, 2015

Error code: ERR_CONFIG/92
C:\Program Files (x86)\EFILive\V7.5\Configuration\cummins_enhanced. prn(968): Units may not be specified for slot: SED-08-5010. .

EFILive Version: 7.5.7 (Build 278)

Sorry for the delay, I did not see your post until now.

The zip file in the known issues thread was updated about 4-5 hours after the initial update to fix known issue 3 - which also caused the problem you have reported.
Please download the zip file and unzip it into the correct folder again.

Regards
Paul