Can I change speed values?

All my speed values are in KMH. Can I change that to MPH?

TIA!!!

Hi CD,

Welcome to the forum. :cheers:

configuring units in scantool:
- on PIDs (F8) tab, on each pid do rightclick->Imperial,
- on Data (F9) tab, verify that that all those pids show Imperial units.


configuring units in tunetool:
Configuring-the-calibration-display-units
Part-throttle-shift-table-conversion
Can-you-go-from-C-to-F-degrees


Also see this (regarding the units of MAP):
Scan-tool-match-tune-tool
Runway-highlighting-not-tracking

Set MAP to Metric (kPa).

Awesome Joe! Thanks! I guess I should have just looked around some more! Dang newbies!!!:notacrook: