Thanks for the reply.
Jay
Type: Posts; User: jay p; Keyword(s):
Thanks for the reply.
Jay
Any chance you will provide support for scanning on this platform or will it work using existing ECM settings? I have a 2019 Sierra and would be nice to use the stuff I have for something.
Thanks...
I'm not sure if the 2500/3500s are the same, but on the 14 and newer 1500s the speed limiter is controlled by the BCM unless it's set to ECM in the ECM tune.
Jay
20049
This too?
www.tunefiledepot.com
I did that same my 2010 LMM. I actually had the pressure sensor pipes installed also and didn't turn off any codes. I never had a check engine light in 30k miles (I sold truck in Dec). The edge...
I agree that a single tune is a better solution, but you should get a key switch to keep it on the lowest tune if you keep the DSP5 tune.
Jay
A lift pump would be a good addition. Be careful when installing the pins in the ECM connector for the DSP switch. There are some good videos showing how to do it I found when I did mine. An exhaust...
I have a 2010 A50 tune from my truck. It's not the same OS, but will upload it if you want it. I believe the OS is 158xxxx.
Jay
The gas torque converter is different from the diesel, so that would add to the cost also.
Here are a couple from my 2006 3500. I think the one with the 2011 date is the cold weather flash (one of them is the cold weather flash). I'm not sure these are full flashes since the A40 PCM has...
Yes, the temps need to be above/below a temp the engine will see.
example: Min engine temp should be higher than the engine will ever see to keep EGR off ( like 300 deg). and Max engine temp...
Is the LMM DSP5 scaling issue and the 2 missing tables (B2256 and B2257) going to be fixed in a future release?
Thanks
Any update on the A50 controller?
I also get build 259 for Scan & Tune. The install file says 260, but 259 is installed.
1744717448
I uninstalled 7.5 and installed v211. I still get the same thing. The DSP fuel press is scaled wrong and the base OS is correct.
Both the DSP5 and base OS calz files were created on...
I see the same thing on LMM DSP5 tunes. Win 7 32bit
I had a similar problem with my 2010 except it was at highway speed. I ended up replacing the MAF sensor and the problem is now gone. This happened at about 100,000 miles. They are not cheap, but I...
I got it.
Thanks
Jay
Can someone send me a stock unmolested tune for my truck? The truck came with someones poor tune and I like to start with a clean file.
Thanks
Jay
If I'm reading this correctly, I will be able to flash old tunes with EGR/DPF changes still there but not have the ability to edit them after updating to new versions?
Did you have a DSP5 os installed when you tried to read voltages? Without it you won't read any voltage change. I went through the same thing when I installed the switch and someone here told me to...
Any reason you recommend the 6128 OS over 6698 & 32483?
Look here, you should find what you are looking for.
http://www.tunefiledepot.com
Jay
I finally got a chance to update the software/firmware and try the DVT controls. All controls now work as expected.
Thanks
Jay
I did a clean install of the EFILive software and resolved the data logging problem.
I still have a problem with the DVT controls not working. What should work on an LBZ? I can toggle the check...