I have had similar issues with a MY16 OS. Started with a 32.16.04.00 and the truck ran good, shifted well and no codes. Switched to 52.16.02.02 for CSP support and the truck threw a few codes here...
Type: Posts; User: BlackCPG; Keyword(s):
I have had similar issues with a MY16 OS. Started with a 32.16.04.00 and the truck ran good, shifted well and no codes. Switched to 52.16.02.02 for CSP support and the truck threw a few codes here...
Doing some testing, if you max it out it does not modify the entire field. It works as designed, just displayed odd.
Yes
When the option to show out of range calibrations is enabled and a cal with a bitmask is loaded, it will show the limit for the entire field rather than just the value that is displayed/saved.
...
I just tried that OS as well as a few others. In any OS is seems to only have issues when a change is made is the trans data.
It seems like v7.5 may be calculating CMD checksum incorrectly. Any file saved in v7.5 Beta-8 or Beta-9 will show an invalid checksum in v8. The checksum shown in v7.5 between 2 different...
Thank you!! Ignore my email...
With a bitmask applied to a 32b signed value, the tune tool will fail to load the tune. If the value is defined as unsigned, it will load the tune properly.
CMD flash times seem to have slowed way down with this update. Standard/Fast CAN/ Fast CAN unlimited all take right around 17-19 min. Previous release (build 315) is ~7-8 min with Fast CAN.
Thanks Paul
When .cax data is defined as signed 32 bit and a bitmask is applied, it will only show the unsigned value in v7.5
https://forum.efilive.com/showthread.php?26884-July-2016-EFILive-Beta-Test-Release/page2
about half way down. I sent you an email with everything else.
Paul -
I'm still having issues with pass thru logging in V8. Same symptoms as the last update. I attached a trace file. 20246
I also noticed under OBD status the OS number is now 0. In the...
Thanks Paul!
Yes
Here you are. I had to change the extension to .txt for it to upload.
20155
I just removed all PIDs except SAE.RPM and it is still doing the same thing. I was mistaken, the orange and green LED blink once then it displays "No Controllers Detected".
This may be user error, but I seem to have no luck getting V8 pass-thru logging to connect to an ECM. Auto-detect, OBD status, and BBL all work properly, but when I attempt to record or monitor data...
When loading a .cax file in build 266 :
If a 3D table is defined, and the X axis is defined by another calibration but the Y axis is a fixed value, it will show an error that the address is...
Still having the issue with .cax file on Build 265.
The address defined in the cax is not $FFFFFFFF
It will not load either the cax or the calz calibrations. It shows unrecognized PCM and saves...
Look through your fuel limiters. Could you post a actual tune file and a log file?
Do you have a log you would be willing to share?
Return the duration back to stock in the idle areas. That should help the lope.
Added D0787 for the 5.9.
In the attached .zip file is the 6.7 and 5.9 links. They are in the new .ini format for V7.5 Build 232.