Calc.VET: correcting MAF and calculating VE (in single log)

[EspenT]

Good job

VE looks quite good (did you use LTFTBEN...? did you disable the MAF when adjusting the VE)...?


I don't know how high your engine revs, but for safety bump up the VE table from 5200 thru to 6400 or 6800 rpm.

Thank you

I followed the Calc VET tutorial to calculate the VE table. Used "Calculated VE, BEN corrected (g*K/kPa)" so the VE is calculated with data from the MAF ?

My next step is to disable MAF and se how the engine would run on the VE table. But due to some unexpected snow I will need to wait for the roads to dry up.