AD Input for wide band
Hi there . Need help with my flash scan V2 . I have been unable to log WB02 data. I have the latest soft ware and firmware version updated yesterday 29/11/16. have read a lot about other users having similar issues. I have gone through and checked flashcan in diagnostic mode. It shows there is a count on channel 1 also checked channel 4 which had the same. I even tried to recalibrate input voltages and no success. It had worked in this way through AD1 with my old Autronic controller. I have since replaced this with our dyno which has a Tech Edge 2DP controller . It is configured to 10-30 AFR which my Mainline have told me was configured the same as the Autronic I had. The signal reaches the V2 but is not diplaying with the pids whether I select Autronic or Tech edge. I also tried using it on the V8 software and most of the PID values are incorrect?? Using it on V7.5 it displays correct values. What am I doing wrong????
Cheers from a novice!!
Reply With Quote