Well I think we are missing a couple of tables still
Like an ECT modifier for adding g/sec for cold starts.
Min airflow is fine once warmed up. But not for cold starts.
Sure there is ECT "Correction" multipliers. But nothing for base idle airflow addition vs ECT.
The reason I mention this is because my 440 cube lump doesnt like cold starts. It fires and dies immediately no matter what min idle airflow I use.
Im going to have to join the rest of you lot and drill the blade. Im sure if there was an ECT adder to base airflow then that would not be necessary.
Cranking idle air is also fine for the initial firing, its when it blends into idle airflow at like 3*C it just dies. Ramping correction multiplier up doesnt do anything useful either.
At around 40*C ECT she settles down and idles much better.
Anyway, the drill is coming out this week hopefully that will give me the base airflow g/sec I need to prevent the cold start stalls.
Originally Posted by ringram
Well I think we are missing a couple of tables still
Reply With Quote
