Updated software/firmware and a new calibration file on its way to you. Thanks
Updated software/firmware and a new calibration file on its way to you. Thanks
24x LS1 PCM on Early Small-Block Chevy and LT1/LT4
http://www.eficonnection.com
To release the pins you need one of these:
You can find them here:
http://www.deutschconnector.com/prod...val_tools.html
They are somewhat fragile so you may want to order a couple extra.
Last edited by vortecfcar; February 24th, 2011 at 05:24 AM.
Can you guys give confirmation that these are deutsch drc connectors? Part numbers? Currently stick using my phone to search the inter-web and it's slow going! Lol
Thanks in advance
doing some more searching. Are you guys using non-keyed connectors or just trimming the keys off? TIA
Could someone please tell me the arrangement of pins on the 06 ecm I have pictured like the 03 ecm I have written the arrangement on. I know the arrangement is different than my 03 ecm pictured. From the picture on the service manual I cant tell if the picture is of the harness and looking at from which side or the face of the ecm. I'm re pinning my original 03 harness to run 06 as a standalone.
Got my v2 scan and tune today. Truck isn't ready to try the 06 ecm but I wanna bench flash it and read the os to send to u and start building a file.. I don wanna go off the pictures because he has c1 and c2 backwards. So, what needs to be hooked up to to this? What pins need power and what ones grounded? What pins go where on the obd2 cable? Any help apreciated..
Spray & Pray
Last edited by comnrailpwr; July 22nd, 2011 at 10:24 AM.
I have a 2006 ECM in my race truck and efi will not talk to it. It can see the ECM but it gets a error when trying to read it. Any ideas on bench flashing would be great.
I will post what pins I hooked to for the data and power wires.
Thanks
1990 CHEVY SILVERADO POWERED BY 03 CUMMINS SHIFTED BY PCS 48RE. BEST ET TO DATE 9.91@150.23 MPH
Nobody has any input for 24vchevy or I???
Spray & Pray
Last edited by comnrailpwr; July 28th, 2011 at 04:40 AM.
I no longer monitor the forum, please either post your question or create a support ticket.