I know you guys are busy, if you have a chance could you please drop my name in the hat for the following table/feature requests:
I have a guy with a stockish tune, delimited but nothing added... But is badly over fueled at idle. Using other software I found the problem to be in a table called base qty vs tps... The table commands excess fuel at 600rpm. I am not able to defuel that table, so I sped up the idle speed to get out of that over fueled zone. I would like to keep idle at 750rpm to line up the needle of my tach with the 750 tick. I'm a little obsessive... But the over fuel problem is in that table and I would like to drop the idle back down to 750rpm if you could get that table put in to facilitate defuling. Specific os is *5504430, but my my16 os *5493455 as well
Also
Is there already mapped out, a way to rescale injection timing axis? The max mm3 value is 120mm, but would like to change that to 130mm3 and rescale the rest of the cells. I can change the labels, but i suspect thats different than changing the axis, can you confirm?
Similar to the SOI tables being commanded out of range:
If using the torque to fuel tables, and i commanded 130mm3 at the top, how does the ecm handle the injector pulse lookup when the pulse table is maxed at 120mm3
Could you explain a little about how the ecm handles looking up SOI for say a torque to fuel value of 130mm3 when the SOI mm3 axis is maxed at 120mm3. Does the ecm use the same SOI values from 120mm3 column and just inject a hair later if 130mm3 is being called for? Or does the ecm extrapolate from the 120mm3 column outward to fuel 130mm3?
Thanks in advance!
Sent from my LG-H918 using Tapatalk