Quote Originally Posted by Blacky View Post
Allow the V2 device about 10-20 seconds while connected to the wide band (i.e. with the orange LED flashing). That will cause FLashScan to record the serial data it is seeing.
Then select the option: F1 Scan Tool -> F3 Scan Options -> F1 Save Trace File.
Then copy the trace file from FlashScan to your PC using EFILive_Explorer and email it to me with a link to this thread.

I'll check what data is being received and why FlashScan won't see it.

Regards
Paul
You still good for people to do this for new widebands that support serial input Paul?

I have purchased a new wideband that uses lsu 4.9 sensors to replace the shitty old lsu 11's for my dyno. the dyno takes the analog signal but I can use the serial output for efilive. :-)
http://www.ecotrons.com/files/ALM-Gauge%20Manual.pdf

is the sensor kit im using.