View Full Version : Gen III V8 Specific
Pages :
1
2
3
4
5
6
7
8
9
[
10]
11
12
13
14
15
16
- Calc.VET, VET Map Average is all 0.0?
- AC Clutch Engaugement
- How does a CASE re-learn work?
- In Memory of Shawn Sankey
- Question about my fuel trim cells
- Bad Misfire and Dieseling Upon Shutdown after Driving in the Rain
- In Memory of Shawn Sankey: Carra Sankey Education Fund
- A/C spark reduction?
- Does the spark table always use GM.DYNCYLAIR_DMA for the Grams/Cylinder reference?
- Why am I running rich during PE?
- Idle spark enable/disable by VSS?
- How can I pass a readiness emissions test?
- Help me understand SD Tunes better
- noob here, need alittle help with my 8.1L
- Bad stumble - what should i log
- Twin Turbo CTS-V help
- Issues with mpg after walbro? Just noticed fuel system fault...help
- Car will not idle...
- Officially Desperate, Asking For Help
- Mail order tune off?
- 240sx LQ9 tuning issues
- Do I have to have a mass air meter?
- PCM is locked
- "Breaking up" when in boost?
- GM 2BAR sensor....
- Throttle follower/ cracker question
- My quest to tune my car...
- 'tuner friend' told me to increase ve table by 10% temporarily-ve questions inside
- LS7 coil for Gen III Tables
- Missing while accelerating - not WOT
- Howdy, another newby.
- question about calc.vet and PE mode
- Closed Loop Filter- Tuning w/o WBo2
- Looking for a stock 2002 Suburban Tune file OS 12216125
- Batt volts vs Flashscan log..
- Need help pcm problems!!!
- 02 switch points
- Newb question: Severe KR.
- Calv VE_Table
- Overtemping at idle or low RPMs
- Engine RPM vs Engine speed
- High MAP after heads and cam at IDLE
- Somethings wrong!! Car adding timing
- I need help, very new too efi live.
- Spark cut RPM limiter
- Help please, PCM in dead poll will not take flash, cos 5 upgrade
- Calc VET
- Cos5 boost and MAF
- General help or suggestions wanted...
- Cl-fault
- Super N00b Looking to make sure i dont mess anything up...
- Please School Me!
- Spark advance drops off to 3 while trying to idle
- Strange behavior of rpm when returning to idle
- want to use a 5.3 to drive hydraulic pump
- Abuse mode in different OS's
- Lots of Knock, is it real??
- DTC codes... Question after latest update...
- 0411 Swap, O2 sensor wiring is different
- Anybody got a cam only tune for a 2002 Z28 a4?
- Custom OS #5
- Can someone take a look at a log for me PLEASE
- Upgrade 2000 Model PCM to COS5 Question.
- OS# 12592425....no 2/3 BAR Custom OS???
- ECM not detected.....HELP!
- Question regarding the Sticky: Calculating MAF Airflow From VE Table..CALC VET In Rev
- 2005 GM 6.0L Crewcab program has no power to pull
- E40 calc.vet??
- transmission questuon
- Need some help with fuel trims.
- Please confirm the Redline Ion MAP/BARO values....
- Need a little help with a DBW to DBC conversion
- Kill low oil level warning
- DBW pedal position correlation with throttle body
- Got a dyno tune. Does this look strange?
- help! went to the track, my car kept getting leaner each pass!
- New to the gassers, Help with 6.0 Suburban tuning due to lack of power
- o2 sensors shot?
- 12587603.pdf file
- Calc vet ???
- Twin Turbo AES 390 in 70 AMC Javelin
- Trouble shooting P0200 DTC code
- First decent log file
- idle trouble
- Ect timing retard though ECT table is zeroed
- Injector voltage correction?
- maffless on a drive by wire 2004 chevy pickup 6.0
- How to efi live my camaro
- 240sx 2003 escalade PCM 1mb question
- turbo 4.8 GMC Sierra
- Is it possible to make ls1 pcm "reference" fuel pressure and correct by it?
- Why Won't it Start Correctly??
- TMAP sensor on E-force supercharger and COS 5
- ID 2000 Injector tuning
- Adjust throttle cracker? Video inside!
- Missfire between 2000 and 3000 RPM
- What pcu and os for 2004 Sierra 2500 HD?
- Cylinders filling with fuel!
- $0537 holden commodore
- Fist start up for conversion! What PID's should I be scanning?
- Power/economy switch role on a GenIII/4L60E setup
- Long fuel trims
- Woundering what modifiers effect p.e. mode
- 8.1L 80mm TB questions
- 98 to 99 Fuel Segment swap gauge output table
- Can someone please help me ?
- 3500 rpm stall convertar truble plz help ?????????????????????????????????????????
- Looking for an experienced tunner in Austin, Tx
- Getting KR only when A/C is on.
- new to efilive with a ls1 to boot!
- Getting Ready To Track My Z06 On a Road Course! How Am I Looking?
- Issue with GM.GEAR
- Data Filters
- Upgrading Operating System - Custom OS Questions
- Is there a way to just disable Reduced Engine Power mode?
- PCM pin for Tacho
- Changing OS in 99 C5 to 12212156
- Lean on stomp
- swapping to a 411 pcm
- New to efilive doing PCM swap have a couple questions
- Cold start question.
- Scan/Tune
- Help!!!!! I have a genIII corvette swap that ran yesterday but won't today!!!!
- Bricked my PCM- What to do?
- How to delet Bank 1 & 2 Downstream O2 sensors?? Please help
- Too Much Timing or Fuel??
- 99 C5 rev limiter questions??
- messed SOMETHING up...horrible mpg after multiple log/tune sessions + smoothing ???
- My 2002 ls1 pcm went dead.
- ANOTHER lockup issue...release problems.
- AFRs
- is B9021 available for OS 12587603?
- 8.1L Marine Injector settings???
- Question on Calc.VET
- Trying to pin down hesitation (logs)
- Dtcs set after ECM swap and repin
- A few log files - everything look okay?
- First time calc.vet attempt, I have issues
- harness and pcm question, swapping in an lq4 in place of my ls1
- 00 to 02 OS full flash issues
- Can't make a gas tune a COS?
- Soft Pedal
- Question about pcm.
- Repairing LS1 pcm.
- SD tune
- Tuning for Larger Injectors
- WOT Issues tuning with Calc.VET
- What pids do I need to log?
- Tune help not going into PE
- VZ LS1 electronic throttle
- RPM Threshold for airflow calculation
- ECM swap, DBW 411?
- "Attached PCM's serial number is missing"
- 1997 Corvette fuel rail and regulator?
- Camaro 6.2l Tuning Help
- CalcVET Question
- complete flash
- VZ Electronic throttle
- Idle Flare Up on start
- 0411 stoich lower limit
- what could cause idle to drop low and not shoot back to normal
- 2006 5.3 Vortec GM truck with mild upgrades tuning help needed
- Looking for OSID 9375577 for 98 LS1
- Help! Only getting 25% throttle with my DBW Pedal.
- New ECM new credit?
- Selben Map?
- Help with transient fuelling issues
- Can I setup a 200 mph speedo?
- ECU Hacking
- Throttle cracker. Does it use corrected airflow values, or base table values?
- AutoVE help
- Ls2 knock sensors on a gen 3
- Wot afr
- quick question - ABS / BRAKE light after Reflash
- stock tune vs one from file depository?
- What's the deal with (B6614) Max Torque by RPM?
- Help !
- stock maf or slp 85mm maf
- 04 Z06 torque management question
- AFR not change
- Looking for tune input
- VE tune -> C6001 -> p0101, p0102, p0103 settings
- help with my 1st tune 01 2500 hd 6.0
- Bad O2's?
- V1 Doesn't Recognize Licensed PCM??
- IAC area and park/reference steps
- airbag light.....
- Spark at WOT goes to 0
- HELP Tuning with no wb? 4.8 with big cam!
- swapping from tuned 98 pcm to 411 and 02 OS
- 2006 5.3 trucks
- 04 gto, can efilive pull abs codes
- 6.0L/4l80E tuning
- Did the auto VE now runs a lot better in SD than with MAF
- 2001 Silverado Magnacharger tune.
- Rich at idle OLSD??? Tune attached, any help?
- 2004 auto 5.7 GTO
- NEW to EFI live, Need help with the order of tuning different areas and tables
- % difference between the low and high octane spark tables??
- I tried the new twist on tuning. Can someone look at my log.
- GM.IAC_LTD_DMA and GM.IAC_STD_DMA are Invalid PIDs
- Idle work, no VE changes but now runs rich
- lc-1 wideband serial - AFR MAP
- DFCO timing
- Base calc file for 2005 Escalade
- Efan troubles.
- pcm still shows 4wd+ trans related question
- Setting up for first log for calc vet tune.
- Need Tune to Pass Smog Testing in Colorado
- Open Loop Fault?
- Scan problems
- Running E85
- can someone check my tune
- 3 readiness test not ready after 2 drive cycles
- Converting TO drive by wire
- 2004 6.0 cng
- VX LS1 cooling fans
- WOT and ZERO Spark
- What is the difference between.......
- Reading tunes written with other tuners?
- Need to mod fuel gauge calibration
- truck wont tune.
- VE table for 427 with TFS 235 heads
- Recommended Injectors for Gen I Vortec 383
- Need help/confirmation with Delphi 42lb (01D030B) injectors
- injector swap question
- new to tuning questions
- GM.DYNAIR vs GM.DYNCYLAIR
- Tuned as a 2 bar MAP but is actually a 3 bar
- Need stock tune file of OS 12593058
- abs light on how to check wheel sensors?
- fuel gauge ohms
- persistant C0055 (wheel speed sensor) after tune
- This is probably a dumb question but I'm asking anyhow
- v2 with LC1?
- 00 gm 5.3 cam heads wont idle in gear.
- Check my data logging
- truck revs to 3000 rpm on cold start for 5 seconds then back to idle.
- Main VE vs Backup VE in 97/98 PCM's
- Converter unlocking at 80 mph
- 99 ls1
- 99 to 02 Operating system swap
- AutoVE help 2000 vette
- torque converter: lock at WOT?
- Lost PCM license?
- Done some idle tuning this morning and now got some codes
- First attempt at CALC VET please check for sanity
- Calc.ve questioN
- Less air when cluth is depressed
- LS1B Black Box Tuning?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.